Call Toll Free: (877) 651-3517
9D Herman Drive. Simsbury, CT 06070 Toll Free: (877) 651-3517 Monday - Friday, 9 a.m. - 9 p.m. Eastern Standerd Time
SP Performance Brake Rotors and Pads Break-In Info.
Proper break-in of your new rotors or pads ensures the maximum performance and durability of the products. The break-in procedure allows the rotors and pads to be brought up to temperature slowly, ensuring even heat distribution throughout the rotors and pads, preventing the brake pads from glazing. This process will also lay down a thin layer of transfer film from the pads to the rotor surface. Improper break-in may result in brake judder, pulsation, or excessive noise, and can also thermal shock the rotor. Brake judder can be caused by the uneven transfer of film to the rotor, causing vibrations that can be mistaken for warped brake rotors.
New Rotors and Pads Break-In
Start by lightly applying the brake a few times. Them from 30 to 35 MPH apply moderate pedal pressure slowing to 10 MPH (do not come to full stop). Repeat 6 to 8 times. Allow brakes to cool for minimum of 20 to 30 minuets. Run the new discs and pads avoiding excessive or high speed braking for approximately 200 to 400 miles for gray ZRC coated rotors, or 300 to 500 miles for plated rotors. Check to see that the plating is completely worn off the braking service.
Street Plus Brake Pads Break-In
"Street Plus” brake pads are formulated with a “Low Resin” formula and do not require a long break-in time. Start by lightly applying the brake a few times. From 30 to 35 MPH apply moderate pedal pressure slowing to 10 MPH (do not come to full stop). Repeat 4 to 6 times. Allow brakes to cool for minimum of 20 to 30 minuets. Avoid excessive or high speed braking for the first 50 to 100 miles.
New Rotors and Pads Break-In
Start by lightly applying the brake a few times. Them from 30 to 35 MPH apply moderate pedal pressure slowing to 10 MPH (do not come to full stop). Repeat 6 to 8 times. Allow brakes to cool for minimum of 20 to 30 minuets. Run the new discs and pads avoiding excessive or high speed braking for approximately 200 to 400 miles for gray ZRC coated rotors, or 300 to 500 miles for plated rotors. Check to see that the plating is completely worn off the braking service.
Street Plus Brake Pads Break-In
"Street Plus” brake pads are formulated with a “Low Resin” formula and do not require a long break-in time. Start by lightly applying the brake a few times. From 30 to 35 MPH apply moderate pedal pressure slowing to 10 MPH (do not come to full stop). Repeat 4 to 6 times. Allow brakes to cool for minimum of 20 to 30 minuets. Avoid excessive or high speed braking for the first 50 to 100 miles.